The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jaros44sr · 10-30-2021, 10:59 AM

Got some more gasket installed, down to the corner, hard part was getting past the bracket for the vent window, you can’t use the sane angle of your push tool, so you have to get both ends started and then push straight down, and hope it grabs, found out that is easier to rotate frame in vise to get the best working position on gasket along with a clamp,of your own design, to keep the gasket in place

Liberal amounts of windex, and gallons of patience

16356051968633727633948790815684 by [url=https://www.flickr.com/photos/97391199@N06

10-30-2021, 10:59 AM	#3315
jaros44sr Registered User Join Date: May 2006 Location: Philadelphia, Pa. 19454 Posts: 9,421	Re: PO has me PO'd Got some more gasket installed, down to the corner, hard part was getting past the bracket for the vent window, you can’t use the sane angle of your push tool, so you have to get both ends started and then push straight down, and hope it grabs, found out that is easier to rotate frame in vise to get the best working position on gasket along with a clamp,of your own design, to keep the gasket in place Liberal amounts of windex, and gallons of patience 16356051968633727633948790815684 by [url=https://www.flickr.com/photos/97391199@N06 __________________ Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim