[jarrodblake]

I moved the driver side shock mount behind the axle to match the dodge bracket.

20211027_210329 by jarrod vanwinkle, on Flickr

20211027_210340 by jarrod vanwinkle, on Flickr

20211027_210919 by jarrod vanwinkle, on Flickr

I cam across some assist shocks for cheap. I don't know if they actually do anything it says it gives any extra 500lbs of load on each shock and supposed to give a little lift idk but they sit at the same height as the old ones. that said i'm running helper bags any ways to help keep the load level. and its way cheaper then replacing the old leaf springs.

20211027_145259 by jarrod vanwinkle, on Flickr

20211027_212021 by jarrod vanwinkle, on Flickr

20211027_213118 by jarrod vanwinkle, on Flickr

Pulled my step fathers boat out of the water on november 1st it was 71 out here it was a warm fall.

20211026_175543 by jarrod vanwinkle, on Flickr

20211026_180542 by jarrod vanwinkle, on Flickr

started on the wide body extensions.

20211104_153546 by jarrod vanwinkle, on Flickr

20211104_161715 by jarrod vanwinkle, on Flickr

20211104_192849 by jarrod vanwinkle, on Flickr

the steel wheels have a slightly deeper offset so I needed to make sure they fit. I have about an inch of room

20211104_202457 by jarrod vanwinkle, on Flickr

20211104_202519 by jarrod vanwinkle, on Flickr

20211105_142617 by jarrod vanwinkle, on Flickr

I ended up going with dodge style u bolts so I had to redo the helper bag mounts.

20211101_194706 by jarrod vanwinkle, on Flickr

20211105_200749 by jarrod vanwinkle, on Flickr

20211106_141838 by jarrod vanwinkle, on Flickr

Had another 71 degree day yesterday november 10th.

20211108_174112 by jarrod vanwinkle, on Flickr

Got one more use out of the grill.

20211110_172043 by jarrod vanwinkle, on Flickr

20211110_172557 by jarrod vanwinkle, on Flickr

20211108_194312 by jarrod vanwinkle, on Flickr

20211108_193520 by jarrod vanwinkle, on Flickr

20211109_163550 by jarrod vanwinkle, on Flickr

Had a new drive shaft made for the rear. and had them balance it and replace the carrier bearings and they replaced the u joints as well. I about had a hart attack when I got the bill.

20211110_191747 by jarrod vanwinkle, on Flickr

20211111_195122 by jarrod vanwinkle, on Flickr

I wired up two 7 pin trailer plugs one for the gooseneck and one for the normal hitch.

20211111_215045 by jarrod vanwinkle, on Flickr

20211111_210344 by jarrod vanwinkle, on Flickr