[buckroseau]

Decided to try using 1 belt for the whole thing. I didn't think the angle would be sharp enough to get much belt to wrap around the generator, but I think it will work. I'm going to mount the pump in a fixed position and use the generator as the tensioner. At least this way I know the pump is spinning at the correct rpm.

Playing around tonight with a piece of 18 ga. steel, fabbed up a mock bracket. It will change slightly, but this bracket will mount on the left thermostat housing bolt and the left water pump bolt. The same bolt that holds the tensioner bracket for the generator.

Going to try to round up some 3/16" flat stock tomorrow to make that bracket out of. Once that is mounted and tacked in I'm going to make a rear bracket. Thinking of mounting to the front manifold bolt.

We shall see......