The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**aotte1** · 11-22-2015, 06:41 PM

Cab tunnels fitted/installed, the front tunnel cover installed with 5/16, .5" long SS bolts. Will weld square nuts to under side floor pan for attaching bolts. The original front was removed at some time in its past. The replacement one was removed from donor by drilling out the spot welds. Because it was removed decided to bolt in for future easy access to tunnel area. The first photo shows the spot welds drilled out from donor floor pan, their were about 35 welds. Second photo shows the spot weld removal tool used, used about four bits to drill out welds, they brake easily.
The third and forth photos shows the tunnels installed. The spot weld holes in the front tunnel cover will be filled with the center disk material drilled out. Will tac weld them in. It all fit very well.

11-22-2015, 06:41 PM	#140
aotte1 Senior Member Join Date: Oct 2013 Location: lousiville Ky Posts: 2,637	Re: 64' K10 Project Long Bed Cab tunnels fitted/installed, the front tunnel cover installed with 5/16, .5" long SS bolts. Will weld square nuts to under side floor pan for attaching bolts. The original front was removed at some time in its past. The replacement one was removed from donor by drilling out the spot welds. Because it was removed decided to bolt in for future easy access to tunnel area. The first photo shows the spot welds drilled out from donor floor pan, their were about 35 welds. Second photo shows the spot weld removal tool used, used about four bits to drill out welds, they brake easily. The third and forth photos shows the tunnels installed. The spot weld holes in the front tunnel cover will be filled with the center disk material drilled out. Will tac weld them in. It all fit very well. Attached Images Last edited by aotte1; 11-22-2015 at 07:18 PM.