[hdrolling]

Next up is to disassemble prep and paint the bed and stain and treat the wood. Looking at using a darker stain but not ready to start that until the bed is painted so I can do my last wood checks before I drill the side pieces.

Already have some marine spar ready to go for the wood.

Just installed a new TCI 500 hp TH350 trans and have a new Blueprint Vortec 350 with 376 hp and 406 tq ready to install. Will be using a 26-2800 stall

Holly sniper EFI has been sitting in a box for a few months, will be going on after the 500 mile engine break in.