[Richard]

My custom made D60 high pinion front axle arrived today! Was a little worried as it was shipped FedEx and sat in San Bernadino since last Thursday. All is good. Looks like paying extra for liftgate service with an appointment paid off. Attached are pics as promised. Axle is configured for crossover steering but not high steer, I am leaving the tie rod in the stock position. IMO it is stronger and I do not need the clearance as I will never go rock crawling in this truck. Need to get hubs off and machined down to accept the Ram rotors on the front side of hubs. Also need new studs for wheels as the wrong ones were installed. Underside of cab is cleaned and coated, frame under cab has the rattle can finish I am using. Goal is to get truck ready for motor/transmission installation next week.