Re: Keep Your Cool! Vintage Air Sure Fit Install in a 67 C-10
The next set of directions is up for debate. Vintage Air says to install the firewall covers early in the install, but I found it difficult to tighten the fittings with it in place, so it MAY be easier to install these later, but I'll show y'all how I installed everything.
So, back under the hood!
I cleaned up my firewall a little bit and painted the rusty, chipped areas.
To install the small round cover, you need to put sealant on the backside (I used 3M caulking you can get from Wally World)
I found the easiest way to install this is to put some tape on the metal backing bracket to hold it in place so you can tighten the bolt.
Last edited by 67ChevyRedneck; 07-29-2007 at 01:56 PM.
|