The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

brantbain · 04-12-2022, 08:49 PM

After the lash was taken up if I tightened it up a typical 1/2 turn it would want to slip right off , if I took it 1/4 it wasn’t really square on the valve but enough to not slide off… until I hit about 4000 rpm

04-12-2022, 08:49 PM	#3
brantbain Registered User Join Date: Mar 2022 Location: Havelock Posts: 6	Re: 67 283 keeps bending pushrod After the lash was taken up if I tightened it up a typical 1/2 turn it would want to slip right off , if I took it 1/4 it wasn’t really square on the valve but enough to not slide off… until I hit about 4000 rpm Attached Images