The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Project 67 DRGNWGN

**kev2809** · 11-13-2021, 05:18 PM

well, was getting ready to mate to the trans and figured I would reseal the output shaft and the slip yoke tube inside since there was trans oil on the u joint when I pulled it from the donor. the tube I can't get local so had to order it off Amazon and won't be in until the week sometime. I did get the shaft seal in...pain in the ass.

if you guys have a rear main seal alignment donut, it fits perfectly over the rubber so you can evenly tap the seal in.

11-13-2021, 05:18 PM	#751
kev2809 low n' slo Join Date: Mar 2009 Location: rosenberg, texas Posts: 5,133	Re: Project 67 DRGNWGN - 67 Burban!! well, was getting ready to mate to the trans and figured I would reseal the output shaft and the slip yoke tube inside since there was trans oil on the u joint when I pulled it from the donor. the tube I can't get local so had to order it off Amazon and won't be in until the week sometime. I did get the shaft seal in...pain in the ass. if you guys have a rear main seal alignment donut, it fits perfectly over the rubber so you can evenly tap the seal in. Attached Images __________________ 67 1/2 ton Suburban - Project DRGNWGN. Build thread -_--_--_ _________ _--_-_ -/____\|__\|__\__ ,.,,,.,.,,.,\|_O _______ O_]