[DT1]

I stripped the anodizing off with a mix of sodium hydroxide and water.
I popped out the dents and sanded out the pits then buffed all of the areas that were going to be shiny and masked off the black area. The black is SEM trim paint. I brushed the lower apron section just to make it sort of a "Three Tone" effect. Then I applied an automotive clear coat to the whole thing and applied the trim black again to break the gloss.
Normally, I would have Re-anodized the thing but I couldn't find any place that had the facility to do it. So, instead I had to clear coat it. It should hold up for a while because I plan to keep it covered and garaged.