[Johns 66]

So while I had everything apart I decided to change both the inner and outer bearings and seals on both front drums....I am gonna have to find the inner seals since the local parts house didn't have any but I'm sure its not too hard...I also bought some rattle can paint...I know the drum looked gloss but that picture was taken when it was wet.

I also bought some "Semi-Flat" paint and sprayed the air cleaner after I cleaned it..Since it had the original sticker on the outside I just taped it off and sprayed around it.

I learned yesterday from Yelmer that I do have the original carb and air cleaner but someone cut off the spout to make it shorter...Have no clue why but it is what it is at this point...not gonna change it and it doesn't look half bad sprayed Semi Flat. Ill post some pictures later of all that.

Tomorrow will see what the damage is gonna be from the machine shop....fingers crossed it aint too bad.