[DeadheadNM]

Thanks guys. The CB is a great idea. I’ll add that to the to-do list. I knew one day I’d find a use for the MM floor mats.

The existing vinyl flooring in the truck is ill fitting over the tranny hump and I’m unsure if it’s OE or installed by an upfitter. I was able to get a good price on a molded gray vinyl mat from ACC for the entire floor that I’m hoping will clean up the look a bit.

On a recent trip out west I was able to pick a few nice parts including power seat bracket for the driver side (just tested and in good working order). This should help the boss see over the steering wheel I’ll clean and lube these ahead of install.

Also pieced together a complete set of GM parts to install correct roof marker lamps including screws, gaskets, and clips. The local Chevy parts guy told me this was the last harness listed in the system nationwide. Here’s the install tutorial I plan to follow: https://www.gmt400.com/threads/cab-light-install.117/ but apparently the female plug is buried deep inside the dash and I need to chase that location down in advance or locate the appropriate wire at the fuse block.