[jodydewey]

I would love to see pictures of everyone elses conversion so I can see some stuff I haven't done yet. Pictures of interest would be the in the cab shots with the hole for the shifter measurement from the center front of the hump. I also agree about the crossmember. I will be using an automatic crossmember since that is what I have. I didn't even think about the height so thank you for that! I will check the angle with my handy dandy angle finder when I put in the tranny. Hopefully it will be 0 degrees. I also don't know about the driveshaft yet. My NV3500 came with the yoke of the old driveshaft and a piece of the old driveshaft. I haven't checked to see if the TH350 yoke and the NV3500 yoke are the same one. I will be putting the transmission/engine in this week for a test fitting. Hopefully all will go well. I will post some pictures.