The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

68 short step · 05-23-2009, 03:36 PM

after i got it all tore down, i put the rear end and trailing arms back in, so i could do a mild c-notch..then i modified the frame to accept the bags..afther that i modified the front arms to accept the bags, the front steering stops will be added later (ill have to make some diffrent ones).....and finally i put the engine and trans in, in preporation to make it a roller again (on 22/20 combo)

05-23-2009, 03:36 PM	#30
68 short step Senior Member Join Date: Aug 2005 Location: tulsa OK Posts: 3,070	Re: project BIG RED (gen3 on air) after i got it all tore down, i put the rear end and trailing arms back in, so i could do a mild c-notch..then i modified the frame to accept the bags..afther that i modified the front arms to accept the bags, the front steering stops will be added later (ill have to make some diffrent ones).....and finally i put the engine and trans in, in preporation to make it a roller again (on 22/20 combo)