Re: "Alternate" Falcon . . . Now building my 53 3100!
A few more . . . . .
1st, sitting a little high, but love the 275's.
2nd-5th - Used the American Powertrain Hydramax hydraulic release bearing for mostly space considerations. Absolutely love it. Had to use offset dowels to get run out in spec; they specify less than 0.007 I think. A few shims, McLeod ceramic clutch. And my method for setting the pedal travel and bleeding the release bearing- bought a 4' AN3 hose and set it all up outside the car. Capped the lines, installed the engine and trans, and it took 5 seconds to bleed in ther car.
More again later- thanks for looking -
Dan
|