The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 47-55.1 Rear roll pan

e015475 · 01-19-2023, 06:12 PM

Mine didn't come with any holes. I put post style LED license plate lights on it - barely adequate. The flip down plate is held up with magnets, which makes it much easier to fuel the truck if you're not fighting the spring. From any viewing angle except sitting on the ground, the 2nd gen Camaro fuel tank isn't visible with the MarK pan

There isn't much of a flange to bolt the sides of the MarK pan to the bed (also MarK) so I used some tank clamps off a Model A Ford (28 or 29) to pinch them together. Youngrodder's solution of welding them together is probably best, but I wanted to be able to take them apart

Another view closed
[IMG]

[/IMG]

01-19-2023, 06:12 PM	#19
e015475 Registered User Join Date: Nov 2013 Location: Show Low, Arizona Posts: 761	Re: Rear roll pan Mine didn't come with any holes. I put post style LED license plate lights on it - barely adequate. The flip down plate is held up with magnets, which makes it much easier to fuel the truck if you're not fighting the spring. From any viewing angle except sitting on the ground, the 2nd gen Camaro fuel tank isn't visible with the MarK pan There isn't much of a flange to bolt the sides of the MarK pan to the bed (also MarK) so I used some tank clamps off a Model A Ford (28 or 29) to pinch them together. Youngrodder's solution of welding them together is probably best, but I wanted to be able to take them apart Another view closed [IMG][/IMG]