|
Re: Dyno'ed 768hp 1305ftlbs & ran a 10.99@122
Quote:
Originally Posted by Super73
At your ride height, can you give us the following:
Axle center height 14.31
Height of the lowest hole for all four rod ends (front/rear hole for upper and lower bars) rear lower=5.87 rear upper=16.92 front lower=4.68 front upper=9.68
What is the spacing for each hole (5/8" centers?) 13/16"
Length of both upper and lower arms lower=22" upper=22.75
My 4-link is set long and low. 5" off the ground and 60ish inches.
|
Thanks for any help. I have some 4-link software that I have been playing with. I just did't know what a good starting point would be.
Thanks
Brett
__________________
1969 C10, 2005 LLY Duramax, Wagler Competition built motor, Bullseye Power triple Turbo's, Rossler th400, Neal Chance Racing Converter, Danville Performance tunning.
8.3@168mph 1700+ HP
|