The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Getting up the nerve to tackle A/C, need to remove the old

**dmjlambert** · 09-27-2020, 04:28 PM

I now have some time to take this evaporator box apart like Original Air should have during the restore. Finishing the job. Rivets were easy to remove, and those same rivets are available new or I can use screws to put it back together.

Does anybody know what holds the pin in the door where I point the arrow in the picture? Is the pin just pressed in there and is it removable and re-installable? I was thinking if possible I would like to remove the door and put it on my workbench when fitting some new rubber on it. It would make the job easier and I would be able to get at both sides of the door.

09-27-2020, 04:28 PM	#23
dmjlambert Senior Member Join Date: Apr 2016 Location: Cypress, TX Posts: 3,572	Re: Getting up the nerve to tackle A/C, need to remove the old I now have some time to take this evaporator box apart like Original Air should have during the restore. Finishing the job. Rivets were easy to remove, and those same rivets are available new or I can use screws to put it back together. Does anybody know what holds the pin in the door where I point the arrow in the picture? Is the pin just pressed in there and is it removable and re-installable? I was thinking if possible I would like to remove the door and put it on my workbench when fitting some new rubber on it. It would make the job easier and I would be able to get at both sides of the door. Attached Images