[Grizz1963]

So yesterday was filled with a load of odd jobs, as was Saturday.

But stuff got done and to be honest, I was still pleased with my progress or results.

The finger getting hurt did not stop me working, it only really went bad last night and overnight, but I should live 😉

I pulled out my large corded drill and fitted the 12mm TiN coated bit.

First hole went through reasonably easy, but it was no 2 that whacked my finger when it caught itself , locking in the steel, spinning the drill and cord around my hand.

So a couple of gentle approaches saw hole no 2 go through fine followed by 3, 4, 5 being easy.



Next job was to remove the trims, glass, and sealant from the full screen that @glenanderson had donated to this build from his stash of spares.

Loads of tiny screws kept it all together, and not one broke, but I was careful all the way.



I also drilled out the backs of the rivets that had held the foamy insulation strips to seal the windows on the doors, mounted on some pretty resilient steel strips.

Then ground the drilled sides back with a flap wheel followed by my electric keyhole sander.

So the rounded rivet heads are still seated on the insides of the frame, looking tidy.



And then measured and marked the holes where the studs will need to go.

Drilling and Tig welding will be next, later.



Later I scraped and cleaned the laminated glass screens as well and washed them.

QUESTION TIME:

How high is the risk of losing one of both screens if I were to firstly find, and then have a glass “specialist” cut and trim 50mm or 2” off the top of these glasses?

I do not really want to destroy them if the risk is too high.

But have seen laminated glass cut on some TV car resto programme.



Advice appreciated

Thanks.


PS:

VERDICT ON THE TiN DRILL BITS.

ABSOLUTELY WORTH THE £22.00 THE WHOLE SET COST ME.

I REALLY COULD FEEL THE DIFFERENCE WHEN WORKING.



.