|
Re: pdx-sanity66
I got a little more done on the passenger side. I got the lower door pillar patch fitted, welded in and ground down, and drilled out the 4 bolt holes so they all line up correctly. Finished welding the inner rocker/floor panel along the vertical side, and started cleaning up and fitting the outer rocker. The outer rocker ended up having a couple of small places that I need to patch before it goes back on but the initial trial fit is great at the front and the rear is unchanged so it is fine. I also need to spray some epoxy primer on the bare stuff before the outer rocker goes back on. Then it's on to the driver side. I'm still looking for a driver side floor/firewall piece (toe board) so I don't have to fab one up. If anybody has a cab they are cutting up or parting out that has a rust free floor section that I can get a patch from, let me know.
I'll post some more pix soon.
|