Thread
:
'88 F*rd Festiva Autocross/Track/Daily Driver Build
View Single Post
07-05-2017, 09:59 PM
#
38
theastronaut
Registered User
Join Date: May 2011
Location: Anderson SC
Posts: 3,870
Re: '88 F*rd Festiva Autocross/Track/Daily Driver Build
Got a good start on the lower radiator support. The driver side is pretty much finished, passenger side needs more work. The plate over the passenger side bumper mount needs more trimming around the A/C compressor but I'll wait until it's on the other car and I have the Sanden compressor to finish trimming it. A lot of guys use an aftermarket aluminum Civic radiator so I'll pick one up and make mounts for that.
I also found the flange measurements for a Honda F22 header to compare to the B6d. I can't find a readily available fwd B6d header but the measurements between the F22 and B6d are close enough that I should be able to buy a B6d flange and weld it onto the F22 header. I'll buy a cheap one off eBay to see if it'll work.
__________________
Project Goldilocks '66 C10 Short Fleet BBW Build
'65 C10 Highly Detailed Stock Restoration Thread
'78 Camaro Targa Roof Build
'55 International Metal/Body/Paint Work
'66 F100 Full Rotisserie Restoration
'40 Packard 120 Convertible Coupe Restoration
How To Restore and Detail an Original Gauge Cluster
How To Detail Sand Body Panels, Edges, Corners, Etc
theastronaut
View Public Profile
Find More Posts by theastronaut