The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Alloyvert** · 05-06-2023, 10:35 AM

Pretty much ready for the install and could use some clarification on the best approach. I have everything out including the bellhousing and the original 4 speed, which is going back in for now.

With the very tall stock 4-speed, does it clear if you install everything at once? It looks pretty tight. If not, can you install the tranny by dropping in through the cab with the motor and bellhousing already installed?

Any advice or suggestions would be very helpful!

05-06-2023, 10:35 AM	#60
Alloyvert Active Member Join Date: Nov 2019 Location: SE WI Posts: 116	Re: Engine Removal Prep Questions/Advice Pretty much ready for the install and could use some clarification on the best approach. I have everything out including the bellhousing and the original 4 speed, which is going back in for now. With the very tall stock 4-speed, does it clear if you install everything at once? It looks pretty tight. If not, can you install the tranny by dropping in through the cab with the motor and bellhousing already installed? Any advice or suggestions would be very helpful!