The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - project "C10 Fever" (68 factory black 396 swb)

**68bowtie** · 08-27-2016, 06:55 PM

so i wrapped up my other project (vitamin c) so i'm getting back onto the 68.

finished installing the brake lines. welded on some brackets and bolted on new tabs since the 71-72 parts connect on the front of the crossmember. installed the sway bar and shocks.

now i have to figure out this stance... the front was too low (see post 54). so i pulled the cut oem springs out and installed new bbc stock height front springs for a starting point (next step is installing the 396). i am liking the 5" drop in the rear, now i need to figure out how much front spring to cut. i'm thinking after i install the 396 and cut 1/2 to 3/4 of a coil i'll have a very slight rake, which would be perfect. until i change my mind again...

Name: 2015-12-26 008.JPG
Views: 1779
Size: 34.2 KB

Name: 2016-08-15 011.jpg
Views: 1782
Size: 40.5 KB

Name: 2016-08-27 002.jpg
Views: 1788
Size: 31.9 KB

Name: 2016-08-27 004.jpg
Views: 1733
Size: 33.4 KB

Name: 2016-08-27 008.jpg
Views: 1762
Size: 34.3 KB

08-27-2016, 06:55 PM	#67
68bowtie Senior Member Join Date: Jan 2007 Location: Turlock, CA Posts: 8,432	Re: project "C10 Fever" (68 factory black 396 swb) so i wrapped up my other project (vitamin c) so i'm getting back onto the 68. finished installing the brake lines. welded on some brackets and bolted on new tabs since the 71-72 parts connect on the front of the crossmember. installed the sway bar and shocks. now i have to figure out this stance... the front was too low (see post 54). so i pulled the cut oem springs out and installed new bbc stock height front springs for a starting point (next step is installing the 396). i am liking the 5" drop in the rear, now i need to figure out how much front spring to cut. i'm thinking after i install the 396 and cut 1/2 to 3/4 of a coil i'll have a very slight rake, which would be perfect. until i change my mind again... __________________ I live in California, but identify as a Texan "If a job's worth doing, it's worth doing well" Project "Little Sister" (70 c10 blue original paint refresh) Project "C10 Fever" (68 factory black 396 swb) Project "Blue Bomb" (70 c30 blue original paint refresh) Project "Vitamin C" (71 c10 orange original paint refresh)