|
Re: 55 make over
day 5: had a few little things going on today so i did this when i could. i started to take down some of their welds around the gas cap they filled in and just like the cab corners their filler plate sat partially on top of the hole. so i cut out the old, made a new one and did what i could. still have a pin hole or two to fill in but at least it shouldn't require 1/4" of filler now. the back of the cab is slowly coming along. we got it to stop tin canning and now my low spots are just a slight hair gap (under 1/16") under my straight edge. i'll probably work out the bottom edge and hit everything a bit more with the shrinker and call it good?
|