The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

dsraven · 02-16-2018, 05:23 PM

1 thing you could do while you wait is find some DOM tubing and fab up a re-inforcing "tube" for the power control arm shaft. it would go between the front and rear of the crossmember and be just as wide as the inside edges of the lower control arm and have the same inside diameter as the lower control arm pivot shaft. it would help support the control arm better. maybe your kit came with that I also install a tab on the frame to suport the rear of that shaft.maybe overkill, but thats me.

02-16-2018, 05:23 PM	#62
dsraven Registered User Join Date: Nov 2010 Location: calgary alberta Posts: 7,854	Re: "52 3600/3100" 1 thing you could do while you wait is find some DOM tubing and fab up a re-inforcing "tube" for the power control arm shaft. it would go between the front and rear of the crossmember and be just as wide as the inside edges of the lower control arm and have the same inside diameter as the lower control arm pivot shaft. it would help support the control arm better. maybe your kit came with that I also install a tab on the frame to suport the rear of that shaft.maybe overkill, but thats me.