Quote:
Originally Posted by jjzepplin
I have a small flux core welder. I don't think that will do the job. I need to get a nice gas regulated unit. I was looking at a Lincoln mig stick tig unit. I sure would love to be able to tig weld.
On a side note. My HP Tuners kit just came in! Let the games begin!
|
A small Flux core should have the heat to weld a nut onto the bad bolt.
If your looking for a upgrade. Hobart makes nice welders, and they are simple to use. They are my personal favorites as I own 2 of them. A handler 190 which is 220v only, and a 220 MVP which is dual voltage.
I use CO2 instead of standard mig gas or C25. It's cheaper, and I always have some due to my job. It cost 1/2 as.much, and last nearly 3 times as long. The only downside side is a bit of splatter.