The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Pump to Carburetor Fuel Lines, what are you all using?

CastIron · 09-13-2015, 01:46 AM

So I think I'm going to run a 5/16" steel line with inverted flares from the fuel pump to an adapter to change to AN -6, then into a swivel coupler and onto an Edelbrock fuel line/filter. I don't like to use that many joints, but I can't seem to find a fuel filter that uses 5/16" fuel line (inverted flare) on both sides. Most aftermarket filters are AN -6 or for rubber hoses. I'm trying to avoid the use of any rubber between the pump and carb.

09-13-2015, 01:46 AM	#26
CastIron Registered User Join Date: May 2013 Location: Oregon Posts: 326	Re: Pump to Carburetor Fuel Lines, what are you all using? So I think I'm going to run a 5/16" steel line with inverted flares from the fuel pump to an adapter to change to AN -6, then into a swivel coupler and onto an Edelbrock fuel line/filter. I don't like to use that many joints, but I can't seem to find a fuel filter that uses 5/16" fuel line (inverted flare) on both sides. Most aftermarket filters are AN -6 or for rubber hoses. I'm trying to avoid the use of any rubber between the pump and carb.