The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Project 67 DRGNWGN

**kev2809** · 08-16-2010, 04:37 PM

well, i went to o reilly this morning and got the biggest supsension u bolt they had, 9/16" thick, 3 3/8" axle size (i think) and 10 5/8" long. they hang down a little further than the other side, but they look like they will work. they are smaller diameter than the one i cut out, but 9/16" should be fine, right?

i got the rearend REALLY close to center, so i will tack weld the extension bar on the panhard, cycle it a few times to make sure its good, then weld it up. should have some pictures this week.

08-16-2010, 04:37 PM	#218
kev2809 low n' slo Join Date: Mar 2009 Location: rosenberg, texas Posts: 5,134	Re: Project 67 DRGNWGN - 67 Burban!! well, i went to o reilly this morning and got the biggest supsension u bolt they had, 9/16" thick, 3 3/8" axle size (i think) and 10 5/8" long. they hang down a little further than the other side, but they look like they will work. they are smaller diameter than the one i cut out, but 9/16" should be fine, right? i got the rearend REALLY close to center, so i will tack weld the extension bar on the panhard, cycle it a few times to make sure its good, then weld it up. should have some pictures this week. __________________ 67 1/2 ton Suburban - Project DRGNWGN. Build thread -_--_--_ _________ _--_-_ -/____\|__\|__\__ ,.,,,.,.,,.,\|_O _______ O_]