So before I get to carried away putting down marglass on the passenger side, I figured I had better test fit the door and Fender again. My door gaps are tight all the way around which is still the way they were the first test fit. I will have to grind down and weld back the skin where ever it spits through on me which will probably be most of it.
My new to me passenger fender seems to fit well other that the lower body line. It is low and if I raise the fender then the bottom will not line up. I will probably end up welding a wire along the edge to line it up with my door. All in all, seems better than the other side. I should only have minimal welding on my rocker edge to line it up with the door bottom.
