Brakes almost done. Had to order some 1/8" wheel spacers so these Torq Thrust IIs would clear the Baer calipers. I thought they would, but the spokes barely graze them. So spacers it is until I change wheels later on.
Ended up making my own brake lines as the premade ones had the wrong size ends on one side. They turned out okay I think. Had about 4 leaks on initial test, but they just required a little more synching and so far no leaking when using full force on the pedal. I'll give it another test tomorrow with the engine running and hydroboost going. If no leaks there then I'd say good to go for a field test!
Also formed my own power steering and hydrolines with some AN fitting and high pressure lines.
Here is some eye candy.
