The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

MP&C · 12-01-2021, 10:14 AM

Thanks guys!!

Last night we changed out the thumbnail shrinking dies for linear stretch dies in the Lennox TE250 in order to tip the flange back horizontal again. We have a backstop / fence that had been notched for tooling and this did a nice job of getting the flange depth consistent.

As this gets bolted to our linear slide and we'll need that to remain stationary, some Cerutti built clamp blocks are added.

Linear stretch dies in action:

https://www.youtube.com/watch?v=-euPrCTj9zI

Next, we had been having issue with the Skat Blast cabinet, and given the sale going on this week at TP Tools, ordered a new high volume cabinet gun and nozzle, some high flow fittings, and while we're at it, how about some fresh glass..

Amazing....we can see!

But alas, all the new parts did not fix the losing media about 5-10 seconds in. So we figured this was a blockage with the suction tube, which requires removing the expanded metal deck inside. Which has sealant along front and rear edge. So a handy utility knife was employed, along with this fancy tool we had made up for removing tiles in raised flooring, as it did well in pulling up the expanded metal.

The screen was tipped up out of the way and a large magnet holds it in place...

Once we had access to the pickup tube, we noticed a hole in the inside corner that didn't belong.

Once we removed the tube, we noticed it was more widespread...

Well, I guess we have found the suction/media issue, and now have a used High flow gun/nozzle for sale. Luckily the sale is still going on, ordered the replacement tube last night..

12-01-2021, 10:14 AM	#1264
MP&C Registered User Join Date: Jan 2013 Location: Leonardtown, MD Posts: 1,633	Re: 55 Wagon Progress Thanks guys!! Last night we changed out the thumbnail shrinking dies for linear stretch dies in the Lennox TE250 in order to tip the flange back horizontal again. We have a backstop / fence that had been notched for tooling and this did a nice job of getting the flange depth consistent. As this gets bolted to our linear slide and we'll need that to remain stationary, some Cerutti built clamp blocks are added. Linear stretch dies in action: https://www.youtube.com/watch?v=-euPrCTj9zI Next, we had been having issue with the Skat Blast cabinet, and given the sale going on this week at TP Tools, ordered a new high volume cabinet gun and nozzle, some high flow fittings, and while we're at it, how about some fresh glass.. Amazing....we can see! But alas, all the new parts did not fix the losing media about 5-10 seconds in. So we figured this was a blockage with the suction tube, which requires removing the expanded metal deck inside. Which has sealant along front and rear edge. So a handy utility knife was employed, along with this fancy tool we had made up for removing tiles in raised flooring, as it did well in pulling up the expanded metal. The screen was tipped up out of the way and a large magnet holds it in place... Once we had access to the pickup tube, we noticed a hole in the inside corner that didn't belong. Once we removed the tube, we noticed it was more widespread... Well, I guess we have found the suction/media issue, and now have a used High flow gun/nozzle for sale. Luckily the sale is still going on, ordered the replacement tube last night.. __________________ Robert Last edited by MP&C; 12-01-2021 at 01:33 PM.