|
Re: 2.5 exhaust kit
I assume the kit works with long or short bed. You might want to confirm that if your truck is a long bed. And make sure the pipes are aluminized!
You know you'll have to make the connections from the collectors back to these pipes, right? You'll need some lengths of pipe for that, and may need to weld together some bends. An aftermarket trans crossmember might make things easier.
Finally, I'd suggest using band clamps instead of old-school clamps that crush the pipes. They are available for butt-joints and lap-joints.
https://www.summitracing.com/parts/sum-683250
__________________
Mike
1969 C10 LWB -- owned for 34 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, AAW wiring harness, 5-lug conversion, 1985 spindles and brakes.
1982 C10 SWB -- sold
1981 C10 Silverado LWB -- sold, but wish I still had it!
1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming.
Retired as a factory automation products salesman.
Worked part-time over the years for an engine builder and a classic car repair shop.
Member here for 23 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then!
|