|
Re: Project: Recycle
Quote:
Originally Posted by TA_C10
Just a note. Having the column that close to the dash. Do you plan to run the rubber boot that fills the gaps around the column and gauge bezel? It won't fit very well if so. Mine is similar with my 2" shorter column and that boot/gasket hits the thicker part of column and gets pushed out so it doesn't fit well.
.
|
Not sure if there was a 'boot' for the earlier trucks. My 3spd didn't have anything. I was probably only putting a u-shaped seal @ max but like mentioned in my prior post I can still shift the column slightly toward the driver as needed.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|