Quote:
Originally Posted by pulltilbroke
Awesome read, I plan on doing this swap in a similar fashion.
My question is is there enough to room between the case side and the hole location to possibly use a 12pt or socket head caps crew on the top holes threading into the bell?
Pics of that area would be awesome
|
If you are referring to running a bolt in from the case side of the transmission (the upper bolts) then I'm pretty sure there isn't enough clearance for the bolt head. In this picture, you'll see that I didn't drill all the way through on the final size because the side of the drill bit would have cut into the side of the trans case. I knew this because I drilled through with the smaller pilot bit and left the bit through the hole, then measured the clearance to the case.
Notice in the picture, only the small center hole goes all the way through...