|
Re: Penny
Steering parts are back together and torqued down.
Had to use an unconventional method to remove the outer bearing race from the rotor. The punches and chisels I have were not able to grab on to the race from the back, so I had to use a pulley puller and a piece of flat steel that used to be a trailer hitch on my 63 to pull the race out enough for the punch to bite. Worked surprisingly well actually. Time to go toss the new races in the freezer overnight, brrr
__________________
Christian Carpenter
1963 C10 - Frankentruck 283, Muncie 3 speed with overdrive Overdrive wiring here 1963-ish truck bed trailer - Half-Wit
1981 C10 - Penny 305, th350 --> Soon to be 350, Saginaw 4 speed
1995 Dodge Dakota Sport
"I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson
|