|
Re: Project: Montezuma
Just found our build from your comments over in Paint and Body.
My truck had very similar rust to yours. I didn't opt for the full floor because it was a lot of money and I could just buy all the patch panels. After I got done, I said I should have got the whole floor. Now, I'm looking at the struggle you had and I feel better. ha
Just yesterday I redid the passenger rocker and cab corner. I'm pretty sure I didn't get the outer floor mounted far enough out. Even though I lined it up with (what was left of) the factory cab corner. There was even less metal on the drivers side and I put the outer floor in once and the had to take it back out and add a pie slice to move it out further at the back. Pretty sure this is what I should have done on the passenger side also, but I didn't know enough to know it at the time. It is what it is now, It's held in too well now and I may have to make a piece to seal the cab corner to the floor since it's not up against it by about 3/8
|