The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Replacing my resistor wire with HEI power supply wire, in pictures

**dmjlambert** · 06-04-2016, 06:24 PM

Part 2

Loosen the bulkhead connector with a 3/8" nutdriver, and slide it apart. Notice the white wire that is cloth-wrapped, that is the resistor wire that leads to the yellow wire. From the inside of the connector, squeeze the terminal with needle-nose pliers while pushing it gently toward the back of the connector.

06-04-2016, 06:24 PM	#2
dmjlambert Senior Member Join Date: Apr 2016 Location: Cypress, TX Posts: 3,567	Re: Replacing my resistor wire with HEI power supply wire, in pictures Part 2 Loosen the bulkhead connector with a 3/8" nutdriver, and slide it apart. Notice the white wire that is cloth-wrapped, that is the resistor wire that leads to the yellow wire. From the inside of the connector, squeeze the terminal with needle-nose pliers while pushing it gently toward the back of the connector. Attached Images Last edited by dmjlambert; 06-04-2016 at 06:29 PM.