[rodstored-72]

Ok, I know it has been a while, but now that I have some time, I thought I would update the build…. Some good things and some bad things…. Good stuff is I figured out the wiring and fuel line routing to finally install the tanks & put the bed on. I ran the wire from the ’13 truck fuel pump to the new ’87 tank switch in the cab. I then ran the 2 power wires from the switch to the tank valve and 6wire pigtail. The fuel line(s) I ran from the tanks (all was stock location) to the valve and then a single line to the corvette fuel pressure regulator/filter and then to the factory ’13 fuel line from the engine. A good friend helped me with all of this and his help was very appreciated. I must also mention that I was lucky enough to get A LOT of help and guidance from Jason Bowman at the BIG10 GARAGE here in the valley.