[aggie91]

Ok, I was going to finish up get my cruise hooked up yesterday and I had a brain blockage...

For the wire that goes from C2 Pin 50 (VSS Out) of the PCM to the K terminal of the cruise module connector, can that be spliced so that it also feeds my electronic speedo?

Also, the Purple TCC Brake Switch wire from C1 Pin 33, can it be spiced so that it get is power from the brake switch at the same time as the wire to terminal D on the cruise module connector?

I know it should work that way, I just needed to ask so that someone can confirm it.

Thanks,