View Single Post
Old 06-05-2008, 12:27 AM   #39
PBFAB.COM
Senior Member
 
PBFAB.COM's Avatar
 
Join Date: Dec 2003
Location: Mesa,Az
Posts: 3,981
Re: Dropmember Rear 63-72 Spy Pic

Quote:
Originally Posted by Rokcrln View Post
So Nate will this work with a 4x4 frame as well as a 2x4 fra, leaf or coil? If so you need to pick up a clean AZ 4x4 Blazer and put your products were your key board is!

LFD Inc.
Kevin-

I don't think this particular piece will work on the 4WD chassis... but that's definitely in the future.

However, on the leaf sprung chassis... the rails are the same as the coil sprung trucks with one small difference, there are ridges pressed into the framerails to cradle the leaf spring perches. This chassis is actaually a leaf sprung chassis. As soon as I finalize the four-link design, I am bustin out my 65 big-window and doing a complete front and rear install... just to "verify" things . For some reason I think that the 65 will end up with a for sale sign as soon as the rolling chassis is Dropmember Equipped.
__________________
www.PorterbuiltFabrication.com

Phone: 480-297-2621

E-mail: sales@pbfab.com


Find us on FaceBook under Porterbuilt Fabrication

Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck.

We offer components from the following manufacturers:

Porterbuilt
Accuair
Ridetech (Air Ride Technologies)
Air Lift
Wilwood
Intro
Unisteer
ECE
Gotta Show
Air Lift
Borgeson
CPP


Supporting this forum since 2003!
PBFAB.COM is offline   Reply With Quote