|
Re: Rat repair.
I got the gas fill door surround cut and made my preliminary layout of where i want the door, I'm not worried about cutting the hole anymore, but i still have some rippling problems I'm trying to get out, i was working the lower portion using the hammer off technique and got a high spot out but in the process it created an even bigger high spot on the upper section..... Go figure
I need to pull my inner bed fender wells soon, i'm seeing some pretty nasty looking rust on the back side where they bolt to the inner bed.
I'll give it another go soon but probably not this weekend, there is a swap meet tomorrow downtown i want to check out, then i got to go to work.
|