The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

LS short box · 02-05-2023, 05:39 PM

Assuming all the ball joints are good what I've done to check camber is cut a piece of steel just long enough to go from the top edge of the rim to the bottom edge of the rim. Don't touch the tire. Hold the piece of steel straight up and down against the wheel rim. I use 6" magnetic level. Then using a magnetic protractor/angle finder find out what the camber angle is.

02-05-2023, 05:39 PM	#4
LS short box Registered User Join Date: Jun 2015 Location: Carlos MN Posts: 1,924	Re: Front Tire Wearing On Outside Assuming all the ball joints are good what I've done to check camber is cut a piece of steel just long enough to go from the top edge of the rim to the bottom edge of the rim. Don't touch the tire. Hold the piece of steel straight up and down against the wheel rim. I use 6" magnetic level. Then using a magnetic protractor/angle finder find out what the camber angle is.