1966 K20 Project

[LeftCoast32]

Well I finally found a good Big Window Cab for my 1966 Factory 4WD.

This is the truck I am doing 1966 K20 Factory 4WD that I am adding 1 1/4 Ton D60 Front Axle and 1 ton Van 14 Bolt Rear Axle.

We are having 3" lift springs made for it to keep all the original grease pins. The axles will give it another 3/4" lift.

I had steel wheels made that have a full steel center. The wheels are 17X9 with 5" backspace to clear disc brakes front and rear.

I am going to run a set of the BF Goodrich Mud TA KM in 37X12.50X17 for the tall tire look.





The Cab has been setting down in El Cajon, CA since 2003 and hasnt been registered since 1993.

It is a 1964 Big Window C30 with Factory Gauges, Heater Delete and Radio Delete with all the original parts still in place.

She was left in Yellow Primer for 8 years in a guys back yard. I wish I could have found her 8 years ago as she would have been perfect.

She is real straight and almost completely rust free other then the small spots on the floors from setting so long without a back window.

I stripped the interior today, she came apart real easy. We are going to pull all the rest apart and remove the body for Media Blasting.

Once back from the Media Blasting we will do any needed metal work before it gets sealed in DP90 and High Build Primer.