need measurements for behind the seat speaker cabinet

[snipescastle2]

Hello everyone! I would like to ask a favor from anyone who can take a few measurements for me, since my cab is out for paint right now.
I need to know the height from the area of the cab floor (where stock gas tank was) to the area
Directly under the area where the top of the stock fuel tank was (under the painted curved cab wall is) that should do it for now. Thanks!
Ben Smith

[droy014]

I would like to have it also if anyone has it.

[snipescastle2]

well, since no one has posted a response, I figure more info must have been needed, so here's a picture I borrowed from another forum member to show exactly what I am looking for:

I need the measurement of distance between the red arrows from the top to bottom at the back wall of the cab, and the distance from the face of the curved wall below the rear window to the floor, and the width of the floor (front to back) where the gas tank bolted to the floor..... hope this clarifies my question.....
Thanks!
Ben Smith

[Vic1947]

Originally Posted by snipescastle2

...I need the measurement of distance between the red arrows from the top to bottom at the back wall of the cab, and the distance from the face of the curved wall below the rear window to the floor, and the width of the floor (front to back) where the gas tank bolted to the floor.

Using the red lines in the picture as the reference, measurements are:

Top to bottom at the back wall of the cab = 20-1/8"

Distance from the face of the curved wall below the rear window to the floor = 20-3/4"

Width of the floor (front to back) where the gas tank bolted to the floor = 5"

Note: these measurements are somewhat approximate as they depend on where you place the tape on the curved edges.

[snipescastle2]

Thanks Vic!!! That was just what the doctor ordered!!! Talk to you later!
Ben