12-20-2022, 10:10 PM | #1 |
Senior Member
Join Date: Jul 2015
Location: Warrenton VA
Posts: 1,084
|
Leveling chassis
I'm getting ready to cut c notches and do other chassis work on a bare frame. What points do you all use for leveling, are these spots good to use for front to back &side to side?
__________________
71 c-10 Long Bed, under the knife for a No Limit Engineering Wide Ride Chassis Pack and coil over static drop. 07 Silverado Classic 2wd 95 Camaro 427SBC/TH350 |
12-22-2022, 11:03 AM | #2 |
Senior Member
Join Date: Jul 2015
Location: Warrenton VA
Posts: 1,084
|
Re: Leveling chassis
Bump, anyone?
__________________
71 c-10 Long Bed, under the knife for a No Limit Engineering Wide Ride Chassis Pack and coil over static drop. 07 Silverado Classic 2wd 95 Camaro 427SBC/TH350 |
12-22-2022, 02:51 PM | #3 |
Registered User
Join Date: Oct 2005
Location: Northern Arkansas
Posts: 1,136
|
Re: Leveling chassis
Looks good. I like to use the bed mounts cause they're normally parallel to the frame.
|
12-22-2022, 10:51 PM | #4 |
Senior Member
Join Date: Jan 2011
Location: Hayes Va
Posts: 4,569
|
Re: Leveling chassis
I always use the top of the frame. Check it in three places front, middle and back to ensure no twist.
Jimmy
__________________
60 to 66 Chevy and GMC window decals http://67-72chevytrucks.com/vboard/s...d.php?t=661131 Good friends, good food and a hotrod what else do you need? 1966 BBW long fleet Daily driver 1965 BBW short fleet Sold and going to a good home 1965 Suburban 2003 3500 Duramax 2005 Ultra Classic |
12-23-2022, 07:44 PM | #5 |
Senior Member
Join Date: Jul 2015
Location: Warrenton VA
Posts: 1,084
|
Re: Leveling chassis
Thanks guys, I'll do just that next week when I get back out in the garage.
__________________
71 c-10 Long Bed, under the knife for a No Limit Engineering Wide Ride Chassis Pack and coil over static drop. 07 Silverado Classic 2wd 95 Camaro 427SBC/TH350 |
12-28-2022, 10:00 AM | #6 | |
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,025
|
Re: Leveling chassis
Quote:
When I built my chassis, I checked @ the front (as far up front as possible); near the center (between front & rear cab mounts), & @ the end of the rails.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
Bookmarks |
|
|