|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-29-2010, 06:42 PM
|
#1 |
|
Registered User
Join Date: Apr 2009
Location: east calais, vt
Posts: 9
|
Front suspension teardown
OK this is probably a dumb question. I've got my '67 short-step blown apart in the barn and the frame up on jackstands. I am to the point of tearing apart the front suspension for cleaning/painting. All sheet metal is off except the cab, the engine and rearend are out. I can't jack the lower A arms to compress the springs to loosen the balljoints, it just lifts the whole truck. What's the best/safest/easiest way to proceed?
|
|
|
|
06-29-2010, 06:48 PM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,919
|
Re: Front suspension teardown
Rachet strap or chain around the a-arms so you can loosen the castle nuts off the BJ's & separate things. If you plan on getting new parts, a torch to cut the springs in half would work too.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
06-29-2010, 07:26 PM
|
#3 |
|
Registered User
Join Date: Mar 2003
Location: San Francisco, CA USA
Posts: 2,454
|
Re: Front suspension teardown
Use a floor jack under the lower control arm. Run a chain under the jack and over the frame rail or crossmember. Pull the chain tight and bolt the ends together. Start jacking carefully until you can be sure the chain isn't going to slip.
Ray |
|
|
|
|
06-29-2010, 11:57 PM
|
#4 |
|
Registered User
Join Date: Apr 2010
Location: Newcastle, OK
Posts: 1,344
|
Re: Front suspension teardown
If you go to O'reily's you can borrow a coil spring compressor for free.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
