The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 09-12-2002, 02:59 PM   #1
Drecarious
Registered User
 
Join Date: Jul 2002
Location: Arkansas City, Ks
Posts: 32
Question Engine trouble....

Just askin' for other Ideas as to what may be causing a few problems with my engine...

it is real hard to set a good idle... 850 out of gear turns into a rough 500 as soon as it goes into gear

recently it's started surging while idling....

any thoughts on this would be helpful.... Thanks


as far as the engine goes.....

283 V8, Edelbrock performer manifold, 1406 carb, original points dist. and a powerglide tranny, that as far as I know has never been opened up...

engine was rebuilt around 6000 miles ago... and carb and intake have only been on for last 600-700 miles..... any suggestions as to what to look for would help.... thanks
Drecarious is offline   Reply With Quote
Old 09-12-2002, 03:10 PM   #2
my67c20
Registered User
 
Join Date: Jun 2002
Location: Tucson AZ by way of WI & CA
Posts: 508
First off how is your timing? Did you set the dwell? Did you set the timing with the vacuum advance plugged?
my67c20 is offline   Reply With Quote
Old 09-12-2002, 03:38 PM   #3
Drecarious
Registered User
 
Join Date: Jul 2002
Location: Arkansas City, Ks
Posts: 32
timing should be OK..... was set right but haven't checked it for a bit.....vaccuum was plugged at the time.... don't know about the dwell though..... haven't checked points lately..... if it's the points I'll probably just throw an HEI in it
Drecarious is offline   Reply With Quote
Old 09-12-2002, 03:44 PM   #4
bigvinnie
Registered User
 
bigvinnie's Avatar
 
Join Date: Aug 2001
Location: escondido, ca 92026
Posts: 1,222
If you've checked obvious things (points, timing, vacuum leaks, etc.), I'd do a compression check just to make sure you're starting with good internals.... then you can dig deeper into fuel and ignition... good luck.
__________________
'72 short step, 350, 700R4, tilt, ps, pdb, a/c, lowered coils, etc., other work in progress... San Diego, CA

72 Stepside Project
bigvinnie is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:31 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com