|
10-28-2007, 06:36 PM
|
#1 |
|
Registered User
Join Date: May 2007
Location: north carolina
Posts: 80
|
caster angle help
i just about have my front suspension built and my control arm mounts are built but my question is how much caster angle do i need. its ind of like a mustang II setup. if i put the ball joints in line with each other that is zero caster i think but can the front end shop adjust it at the upper mounts?if not how much do i need?
|
|
|
|
10-29-2007, 04:28 PM
|
#2 |
|
Registered User
 Join Date: Oct 2005
Location: Overland Park, Ks.
Posts: 5,193
|
Re: caster angle help
About 1-2 degrees will be about right. You will need a caster-camber gauge to measure it. It probably has slots in the upper control arm mountings to adjust it.
|
|
|
|
|
10-29-2007, 06:48 PM
|
#3 |
|
Registered User
Join Date: May 2007
Location: north carolina
Posts: 80
|
Re: caster angle help
when i made the upper mounts i did put a 1.5 inch vertical slot for adjustment but i didnt know if it would adjust caster as well as camber.
|
|
|
|
|
10-30-2007, 09:58 AM
|
#4 |
|
Registered User
Join Date: Oct 2005
Location: Overland Park, Ks.
Posts: 5,193
|
Re: caster angle help
Yes. To adjust more caster move the front bolt out & the rear in an equal amount & you will have the same camber.
|
|
|
|
|
10-30-2007, 10:19 AM
|
#5 |
|
Registered User
Join Date: May 2007
Location: north carolina
Posts: 80
|
Re: caster angle help
thanks alot so that means i dont need to change my mounts.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
