Took my truck in to get cut up!

[Brad]

Over the last couple of weeks I've been doing some minor stuff which included taking a wire cup on my grinder to the bed floor. I got most of the rust off(I wonder if this was in a fire? - it was bad!) I went through 2 wire cups on this bed and I'm still not totally done. I still have to get the very back edge near the tailgate. Afterwards, I sprayed the store bought bedliner stuff and used 2 cans which also covered the wheel wells. This has worked great for me in the past, but I don't use the bed a whole lot and I keep a tonneau cover over it to keep the weather out.

Friday I should get my driveshaft back from the driveline shop and I'll install it. A couple days ago I worked on installing my blazer gas tank back in and making the fuel line fit. I also began cutting out my low hump and I'll be replacing it with another low hump trans cover for now until I can get a nice 5 speed down the road.

Also, I hooked up everything to the cab and tightened up my E-brake cable. Next I'll be reworking my clutch rod with heim joints and making it slightly longer so that I don't have to push all the way to the floor. I'll also be cleaning the cab out entirely and working on putting new chrome vents in the doors before they go back on.

I'll try to add more pics in a few days.