|
05-05-2002, 11:01 AM
|
#1 |
|
Car Knocker
Join Date: May 2001
Location: jefferson,arkansas
Posts: 664
|
Cab Support question
I'm in the process of repairing my cab. After cutting the floor out and the cab support I noticed that one of the supports was not welded. The support in question is the one running from front to rear. Right where it meets the angled one from the firewall support it is not welded, just kindof sitting on top of the one from the firewall. The place in question is right under the pedals. Is this the way of factory to allow flex? Or should I weld it up? Thanks for any suggestions.
------------------ 68 c-10,91 sportside bed,350 .030 over,4 bolt,10-1 comp,1.6 Harland Sharp roller rockers,edelbrock rpm cam and intake w/750 carb, 700r4, 3.73 gears,Jacabbs Electronic Igntion. ZR-1 roll pan, filled tailights.Parts bought but not installed>> 1985 front disc suppension, ford 9" posi with disc.Cab corners,foor boards,rockers, cab braces, Phatom grill. Steel Horse leather seats with console. My wife is gonna kill me.
__________________
68 c-10,91 sportside bed,350 .030 over,4 bolt,10-1 comp,2.05 intake/1.94 exhaust,1.6 Harland Sharp roller rockers,edelbrock rpm cam and intake w/750 carb, 700r4, 3.73 gears,Jacabbs Electronic Igntion w/Accel HEI distributer and super coil. ZR-1 roll pan, filled tailights. Blazer tank. Hidden hitch. 2 1/2" Flowmaster 40's. Parts bought but not installed>> ford 9" posi with disc. CCP front and rear lowering kit 4/5. Cab corners,foor boards,rockers, cab braces, Phatom grill, Painless wiring kit. |
|
|
| Bookmarks |
|
|
Threaded Mode